Heater Air Solar bertekanan kompak (TYF-FS)

Consideration should be given to utilizing solar hot water heating system on all project where:
1. The avoided cost of energy is high(gas not available, electricity rates above $0.034 per KW).
2. There is a dependable, consistent hot water requirement(such as enlisted quarters, laboratories or hospitals).
3. There is reasonably high daily average solar radiation rate on a titled surface, although if the avoided cost is high enough solar water heating is effective in most climates.
4. Energy security is important, such as on an international base where energy supplies could be interrupted.
For large facilities, active and indirect systems are most frequently used. For smaller facilities in mild climates with modest freeze threat, passive direct or indirect systems are also a viable option.

Specifications:
1. Material of inner tank chest is imported food grade SUS304/2B with 0.4mm thickness.
2. Material of outer tank shell is galvanized plate.
3. Support material: Galvanized the steel plate Thickness: 1.2-1.5mm
4. Heat insulating layer: Improved polyurethane integral foaming with 55mm thickness
5. Φ 47*1500mm: Size of inner tank chest 320mm, size of outer tank shell is 420mm
6. Φ 58*1800mm: Size of inner tank chest 360mm, size of outer tank shell is 460mm
7. Vacuum tube: Pyrex glass, magnetron sputtering aluminum nitride coating
8. Vacuum tube standard: 15/18/20/24/30/36/40 tubes with Φ 47*1500mm and Φ 58*1800mm
9. Pattern of water tank: Inflow side
10. Heat preservation: 72 hours
11. Standard pressure: 0.6 Mpa
12. Fastness: Stainless steel screws
13. Seal: Silicone rubber polymer