| Tampilan: | Cairan |
|---|---|
| Penggunaan: | Agen Bantu Pengeboran Oli, Perawatan Air untuk Bahan kimia, Agen Beary Auxiliary, Agen Bantu plastik, Bahan tambahan Lapisan, Agen tekstil tambahan, Kertas kimia, Surfaktan, Agen tambahan kulit, Elektronik Chemicals |
| Warna: | Putih |
| 800: | 0+2 |
| 805: | 10+2 |
| 815: | 15+2 |
Pemasok dengan izin usaha terverifikasi
Pemasok yang Diaudit 100:2 two-component liquid silicone rubber belongs to condensation type mold silicone rubber. When part A and B are mixed in 100:2 weight, the crosslinking reaction can occur, and the elastic body with certain hardness is formed after curing. It has many advantages, such as good fluidity, easy to operate with low viscosity.
After curing, it has heat resistance, high temperature resistance, corrosion resistance, solvent resistance, high tensile and tear strength, low linear shrinkage, high turning model times. It is a cast of gypsum, cement, POLY-RESIN, PU, AB water, ABS material of the elastic mold material, it is widely used in the production and reproduction of sludge, toys, gifts, reliefs, statues, city sculpture, cement products, hand plate, car model, model of home appliances, mold products such as soap.
Technical data:
Products Procedure
1. Choose smooth material to make the mold frame, such as an acrylic plate.
2. According to the actual situation, the master module is put in the frame and fixed.
3. Spray a little release agent in the female die and the die frame wall.
4. The silicone rubber and curing agent are mixed in 100:2 weight ratio and fully mixed evenly.
5. Vacuum exhaust bubble treatment.
6. Pour the bubble in the mold into the mold box.
7. Put the model frame into the vacuum machine according to the actual situation,. (optional).
8. Wait for stripping can be cured.
Precautions For Use
1. Before large-scale use, please do small amount of trial, familiar with the production skills to avoid errors.
2. Do according to the manufacturer's instructions ratio for quantity, and the weighing accuracy, please remember that the ratio is by weight rather than volume. After the mixing of AB silicone rubber, stir it fully to avoid not cure or incomplete cure.
3. If you want to speed up the curing time, you can heating up when liquid silicone rubber initially solidified, but could not heating up immediately after pouring which will cause non-curing because of the volatilization of curing agent.
4. When mixing the AB silicone, mixing in the same direction. When pour glue, take a little bit of the higher and same position on the female die on the same position, let the glue flow flat on the master die, it will increase the flow time of the glue to reduce the bubble.
Pemasok dengan izin usaha terverifikasi
Pemasok yang Diaudit 
